Wd Scorpio Blue 500gb Drivers For Mac

Posted : admin On 17.01.2020
Wd Scorpio Blue 500gb Drivers For Mac Average ratng: 9,6/10 4374 reviews

Has anybody had any problems with new MacBook Pro after yesterday's firmware update with third party hard drive? I got a MacBook Pro 13' recently, swapped the 320 GB hard drive from my old MacBook. After reinstalling the OS for new hardware drivers, everything was working fine.

I recently upgraded my MB HD. My 2.4ghz Alum Macbook came with the Toshiba 250GB 5400rpm. Then I upgraded to the 320GB 7200rpm WD Scorpio.

After the firmware update yesterday, the machine has started freezing randomly; the spinner comes up sometimes when reading or writing to the drive. The hard drive, a WD Scorpio Blue, supports SATA II. My suspicion is that there are intermittent data errors when using the SATA 3 Gbps interface. It could be an incompatibility between the controller and drive or the ribbon cable isn't good enough for newer SATA. Does anybody know of a way to force the drive or the controller to use SATA 1.5 Gbps?

Can I revert to the old firmware? OnLnAgent wrote: You can restore the firmware from CD. See for more information.

OnLnAgent - you may want to read the kbase article you to which you are providing a link. It states that a Firmware Restoration CD can only be used +'.to restore the firmware.after an interrupted or unsuccessful update.This CD cannot be used to return an Intel-based Macintosh computer's firmware to a previous version if a successful update has already been performed.' + An interrupted or unsuccessful update means a computer with serious issues (i.e., cannot boot from the internal drive). In the OP's case, the firmware update was successfully installed (even though that installation has resulted in issues), so the Firmware Restoration CD is useless. I think I'm seeing the same thing.

I just bought a new MacBook yesterday and asked for a hard drive upgrade to 320gb, 7200rpm, and they gave me the WD Scorpio Blue (which I noticed because that's probably the dumbest name I can think of to describe a hard drive). I took it home and put in the new disk, and it's the same freezing behavior. No disk access can happen at all for 20-30 seconds, then usage spikes, then no disk access at all.

It upgraded the firmware right after I installed the OS, and I'm pretty sure that's what started the issue, since it installed the OS quickly enough and booted much quicker. Though I'm not positive because I didn't use it for long before the upgrade. I took it back to the store and they say it works fine with the pre-installed HD (250gb, 5400rpm) but not with anything else they put in there.

So I'm waiting for another call to see if I'm just going to have to deal with the factory drive. I am seeing simular issues with my WD Scorpio Blue 500GB SATA II drive after performing the firmware upgrade. I've called Apple support and have also been to the Apple Store and neither could help me resolve the problem. My new MacBook Pro's performance has gone down the toilet since this latest firmware upgrade. It's bordering on un-usable now.

Wd Scorpio Blue 500gb Drivers For Mac Pro

Since it appears that there is no way to un-install the firmware upgrade, the Apple folks suggested that I do a clean install of the OS to see if that fixes the performance problems. It sounds like if I plan to use the 500GB WD drive I just received from Amazon, I better avoid the firmware upgrade. I did notice in the statement Apple made about the firmware that although the SATA speed is now 3.0Gb, all of the traditional hard drives that are available with the latest MBP's are 1.5Gb. Thus, I see no value-added to a faster controller unless you're going with SSD. What sense is this upgrade if it renders the notebook non-upgradable? I can't believe that Apple would let this go on for long.

Hard drives fail, and a notebook with such a finicky controller is going to be mighty hard for Apple to support in warranty if a mainstream hard drive won't work - even at 1.5Gb. I just got a new MacBook Pro (2.53ghz 15' model). I installed a Seagate 7200.4 500gb drive which works perfectly in my old MacBook Pro (Core Duo 2ghz). Since applying the firmware update I'm experiencing the same problems as IanBurrell, random freezing and spinning wheel.

It will also fail to boot sometimes. In verbose mode you can see read errors when trying to load the kernel. I tried jumpering the drive to allow 1.5gbps sata only and it actually worked well for a while (was able to copy 7gb of data before problems, rather than only 100mb) but ultimately started freezing and giving read errors on boot again.

I hope apple can come up with a fix for this - or at least a way to reverse the firmware update. It seems the restore CDs don't support the new Machine IDs at the moment either. Well, After dealing with this issue ALL DAY, I am finally back up and running. I ended up having to re-install my original 250GB HDD that came with my MacBook Pro. After a clean installation of OS X 10.5.7, I then restored my data from a Time Machine backup and it looks as if all is well, so far at least.

Just for kicks, I put the WD 500GB HDD back into the MacBook Pro, and confirmed that the same performance issues still existed. So, it appears as if the EFI 1.7 firmware update has a problem with the WD 500GB HDD, at least in my case it does. So this is scaring me.

I'm contemplating the retirement of my dear old 12' Powerbook with the new 13' Pro. I was going to get the lower end model and DIY upgrade but then there was the SATA issue (even though it doesn't effect traditional drives). Then that was fixed, WoooHooo!!!

No wait now there's problems again. Good thing my 12' is still a healthy work horse. Does anyone know if the firmware update applies to the 2.53 model which is supposedly ready for SATA II correct. If not I'll just spend the extra dough and buy it to avoid all the firmware issues.

Wd scorpio blue 500gb

I gotta have at least 500Gs. 'Anybody buy the 500GB SATA drive as a CTO option from the online Apple store? What is the model & manufacturer?' I have the 500GB 7200 rpm SATA drive and it works fine it is a seagate and here is a link to the product info: This is what the Macbook is showing after the firmware update: NVidia MCP79 AHCI: Vendor: NVidia Product: MCP79 AHCI Speed: 3 Gigabit Description: AHCI Version 1.20 Supported ST9500420ASG: Capacity: 465.76 GB Model: ST9500420ASG Revision: 0006APM2 Serial Number: 5VJ.KT Native Command Queuing: Yes Queue Depth: 32 Removable Media: No Detachable Drive: No BSD Name: disk0 Mac OS 9 Drivers: No Partition Map Type: GPT (GUID Partition Table) S.M.A.R.T. Buy xilisoft youtube hd video downloader for mac.

Status: Verified Volumes: Macintosh HD: Capacity: 465.44 GB Available: 363.87 GB Writable: Yes File System: Journaled HFS+ BSD Name: disk0s2 Mount Point: /. Apple Footer. This site contains user submitted content, comments and opinions and is for informational purposes only. Apple may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Apple can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums.

Wd Scorpio Blue Driver

Apple disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the content on this site are subject to the.

Hi Donna, Welcome to Microsoft Community and thank you for posting your query. Let’s try installing the WD passport driver in compatibility mode and check if this helps. I suggest you to install the drivers supplied by the manufacturer any disc or USB which came along with the WD passport drive.


Right-click on the setup file of the driver and select Properties. Select Compatibility tab. Check Run this program in Compatibility mode. Let the driver install and then check the functionality. You can also visit the below link and try updating the driver and check. If the issue still persist, I recommend you to contact WD passport team for further assistance. Hope this helps.

Wd Scorpio Blue 320gb

Keep posting us with the status we will be glad to help you. Hey again:) This should give you a good amount of info including how to check the contents of the backup: I would recommend backing up your data with another tool to an external drive just to be on a safe side that you have a current backup of your data. You can try using WD SmartWare: If you have questions for regarding software or anything else feel free to ask:) CaptainWD.